Superior Protection from Line X

 

LINE-X consists of several different products.All systems utilize a two-component, spray-in-place, 100% solids (no air pollution), thermoplastic polyurethane and polyurea. There are two separate materials that are precisely dispensed through a high pressure, plural component internal mixing polyurethane spray machine. They are each heated to 120-140 degrees with the temperature maintained through a heated hose. Using high pressure, the materials are mixed internally at a 1:1 ratio at the tip of the spray gun. As the material is applied it takes less than 5 seconds for it to harden. As soon as LINE-X lands on the surface it's dry!

 

Fast cure time means, no runs or drips.

LINE-X products are a fast-cure, multipurpose series of coatings designed for a wide range of retail, commercial, and industrial uses. They exhibit excellent adhesion to most properly prepared surfaces. With its fast cure time it can be sprayed vertically and even overhead without running or dripping. There are no solvents associated with LINE-X products, which means there are no air pollutants or harmful environmental contaminates.

 

 Hard as Heck and Water Tight

LINE-X Protective Coatings are resistant to most solvents and acids, making them ideal for industrial and commercial applications where corrosion is prevalent. Using LINE-X greatly extends equipment and vehicle life expectancy. It has a high "shore D" hardness rating, offering excellent impact resistance and superior tensile strengths (up to 6,600 psi) resulting in outstanding abrasion resistance. Because the material is sprayed there is a complete seal, making the coating "water tight".

 

 Watch the video to see the LINE-X spraying process in action.

Unlike other spray-on or drop-in bedliners, a LINE-X® treatment is professionally applied at high pressure and high temperatures, bonding instantly and permanently to your truck.

Made from a two-part polyurethane elastomer system, LINE-X uses equal parts of an "A" component, or hardener, and a "B" component, or resin. Using special equipment, the two liquids are combined right outside the tip of the spray gun. When the two parts are combined properly, the result is a polyurethane elastomer with tough, durable, protective properties.

The LINE-X dries in just 3 to 5 seconds, preventing runs or pooling that can occur with a cold, low pressure spray-on product. With a pre-scheduled appointment, the total job (including bed preparation, masking and spraying) takes about two hours and your truck is ready immediately, but wait a day before you put it to the test.